Structural composition:

1、 Weighing instrument

1. Comprehensive error of instrument:<0.02%

2. Sensor input port: 6 350 ohm sensors can be connected, and the sensor sensitivity is required to be above 1.5mv/v.

3. Weighing instrument: 32 bit ARM CPU is used for high reliability and fast operation.

4. Wide power supply design: 85V-260V 50HZ

5. 24 bit ADC sampling module, speed 240 times/second. Chinese and English menu display, 6 channels of switching value, 2 channels of analog input and 2 channels of analog output. Large LCD display. The standard RS485 interface (modbus protocol) can fully connect with DCS.

2、 Speed sensor or encoder

1. The pulse shaping circuit is added to the speed measuring input of the speed measuring sensor, which can make the speed measuring result more accurate and stable.

2. 8030-1024 photoelectric encoder φ The roller at the end of the axle hole is directly connected, with good concentricity and long service life. Strong anti-interference ability.

3、 Load cell
The weighing sensor with high sensitivity of more than 2mv and temperature compensation function shall be used to adapt to the environment of - 30 ° C - 60 ° C. No drift, stable operation, high accuracy.四、优异变频器
采用国外或国内一线品牌，高性能矢量控制技术，具有调速范围宽、调速准确和强过载能力，充分满足定量配料控制需求。

Scale body characteristics

1. Scale frame:

The scale body is made of 5mm cold-rolled plates, which are bent into a C-shaped frame structure at one time. It has high strength, stable structure and is not easy to deform.

2. Drive:

The transmission device (motor reducer) adopts SEW or SBD Schenck scale special reducer, which is installed in the shaft hole suspension direct connection mode, and the chain plate is driven by the active roller to run directly (without vibration and smooth movement).

3. All bearings of chain plate scale adopt imported bearings, which are waterproof, firm and durable. Fully adapt to harsh environment and have a long service life.

4. The feed inlet is equipped with a material flow shaping ram to facilitate the adjustment of the material layer thickness.

5. Both sides of the scale body are equipped with (emergency stop) switch devices to connect with the controller, which can realize on-site power-off and shutdown, and make maintenance safer and more convenient.

6. The gantry is used to hoist the tension sensor, which overcomes the influence of temperature on the sensor.

Product live shot:

Technical parameters: (customized as required)

Project case: